Seven major problems need to be paid attention to when using a mill

Raymond mill is the main equipment needed in the grinding process, so what problems should be paid attention to during use? The following editor will give you an inventory of 7 aspects that you need to pay attention to during use:

 

1. During the use of the Raymond mill, a fixed person should be responsible for the supervision, and the operator must have a certain technical level. Before installation, the operator must be given necessary technical training to understand the principle and performance of the Raymond mill and be familiar with the operating procedures.

 

2. Since the Raymond mills generally work outdoors, and the crushed materials are some large ores, the operators of the Raymond mills must always pay attention to strictly prohibit metal blocks from entering the machine, and immediately shut down and take them out,otherwise it will damage the grinding roller and grinding ring;

 

3. When the Raymond mill is in use, the moisture of the material needs to be strictly controlled. Materials with too high water content can easily cause the fine powder in the mill to occupy the grinding body due to excessive viscosity, which will seriously affect the quality and output of the product;

 

4. The feed must be carried out in accordance with the prescribed standards, otherwise it will cause uneven, coarse, and fine particles, which will affect the grinding effect;

 

5. It is necessary to grasp the adjustment of air volume, and adjust appropriately according to the fineness and output requirements; whether the air volume is too large or the air volume is too small, it will have a bad influence on the effect of the Raymond mill;

 

6. Secondly, after the Raymond mill has been used for a period of time, it should be overhauled. At the same time, the wearing parts such as the grinding roller, grinding ring and blade should be overhauled and replaced. The connecting bolts and nuts of the grinding roller device should be carefully checked before and after use.See if there is any looseness, and if enough lubricating grease is added.

 

7. Master the correct method of stopping. Stop feeding before stopping. After a while, the power can be cut off when there is no remaining material in the silo of the Raymond mill. After stopping the grinding work, stop the fan motor,in order to blow off the remaining powder.

 

As a professional manufacturer of grinding mills, Shuguang Heavy Machinery sells a variety of different types of mill equipment, including ball mills, Raymond mills, vertical mills, etc.Welcome to contact us for more details.

 

Factory Address: Longjiang West Road, Shangjie District, Zhengzhou City

Contact number: +86-371-67666660 676667

Mobile phone: 0086 13523465141

After-sales Service Department: 0371-67666667