What are the details of installing Raymond mill?

Raymond mill needs to pay attention to the following things when installing
Raymond mill needs to install 5 swing attachments. First, use the tool to remove the cover of the roller sleeve, and gently remove the shaft sleeve. To remove the ring bolt from the bearing of Raymond mill on the top of the bearing, and install with electric hoist, it can be hoisting to the top, and no deviation can be found.
After the rollout of Raymond mill is completed, the bearing sleeve will be put on again, and then the lid will be closed. The type of the bearing is all marked, and corresponding to the number of the mace is corresponding to the installation of each gap.
Make sure the grinding roller is installed correctly and check for leakage. When the pendulum is rolling down, the roll-mounted rollers should be close to the lower grinding surface. Start rotating equipment after the operation, the plum flower, this time roller roller begin to spin, then begin to grinding operation, if the height of the roller and the bottom is very big, it is difficult to grind material, speed of operation are influential, if the roller and the bottom is too small, grinding strength increase, to equipment electrical demand is high, at the same time also does not favor the equipment used for a long time.
The engineer confirmed that Raymond mill had been rolled and installed, inspected each bolt, and then added lubricating oil for long use.
The installation must pay attention to the details of its contents. If the details are not handled properly, it will damage Raymond mill in the daily production process and reduce the life of Raymond mill!