Installation method of granite Raymond mill

  Raymond mill is easy to install, because Raymond mill belongs to the smallest Raymond mill, the installation process can not use lifting equipment. Taking granite Raymond mill as an example, the installation steps are as follows:
  First, granite Raymond mill installation preparation stage, plant and power supply should be prepared, granite Raymond mill oad width is about 3.5 meters position, height 3.8 meters, the height and width of the plant size to leave room, facilitate maintenance and feeding and discharge. Workshop to do have a 10 centimeters or so the thickness of the cement floor, does not require the whole factory covers 10 centimeters thick cement, only need to put the host of Raymond mill and fan position can make 10 centimeters thick cement. The other parts can be about 5 centimeters. To be ready to install the tools, general general tools can be solved, such as the wrench two or more, the connection pliers, the crowbar, etc.
  Second, granite Raymond mill installation phase, installation phase main work is both a place granite Raymond mill host at a predetermined position, lower the rubber gasket, installing bolts in cement floor. After the host is installed, start connecting the main engine and fan, the fan and the tee to use the bolt connection, the tee and the host adopt soft connection. Then place the cyclone separator and dust collector on the scheduled location, then connect the remaining pipes. When connecting the pipe, pay attention to the sealing of the pipeline to prevent air leakage. The link of the granite Raymond mill is connected, and the connection of the three motors is completed. The installation phase is completed.