The new Micro Powder Mill shows the value of the product！

Present a new type of Micro Powder Mill has many advantages, such as the size is appropriate, simple operation, high yield, high efficiency, low power consumption, strong popularity, processing enterprises to adapt to the simple, can be fixed and mobile, many sets of parallel and single production. Traditional Micro Powder Mill Powder machine has been popularized and applied in processing of non-metallic minerals, familiar with by most of the mineral processing enterprises, in the domestic industries have considerable ownership, however, with the development of nonmetallic minerals in recent years, the downstream enterprises more and more high to the requirement of non-metallic minerals, especially higher demands on product fineness. The traditional Micro Powder Mill is becoming more and more small in the non-metallic ore processing.

Problems existing in the traditional Micro Powder Mill is becoming more and more serious, and seriously affect the quality of the products and economic benefits, the dawn of the new Micro Powder Mill to challenge to the traditional problem, mainly to solve several problems: the host bellows duct had made a mistake, a juice into the grinding zone before the larger particles and grinding material particles are often thrown into bellows accumulate in the tail of the spiral case, the continuous extension of the well, the air volume gradually reduce, easy cause plug, not Powder Powder or less, affect the production. The product is of low quality and can not meet the requirements of the manufacturer's fineness of the powder. Therefore, the product value is low and the economic benefit is low, and the low-end market can only be occupied by the powder application enterprise below 800 eyes. High mechanical failure rate, high power consumption, high noise, pollution discharge; The system efficiency is low, the separation effect of the product collection system is not ideal, and the fine powder is not effectively collected and the internal recirculation of the system is wasted. The new Micro Raymond Mill can be perfect only if the problem is solved.