The preparation principle of the stick mill machining program.

May not know a lot of customers, the roll mill powder machine procedure formulation: flour processing internal gear forming roll grinding machine using Siemens 802 c roll mill system, roll mill powder machine system programming method mainly has two ways: one kind is computer programming, it can be online programming off-line programming, the workpiece program compiled by using special software on computer, and then through the RS232 interface to roll mill system is saved in the machine tool processing program storage, processing and v can be realized automatically processing: another kind is to manually enter programming, namely by the programmer from machine tool roll mill system operation panel manual input processing program of the system. Because the internal gear forming grinding process is simple and easy to program, we adopt the manual input programming method. According to the forming machining principle of the internal gear rod grinder system, the parameters and machining accuracy requirements of the machining gear, the logic block diagram of the gear inside the straight tooth is drawn. In order to better ensure the symmetry about gear tooth surface, with the forming surface of mill has been into shape, the rod of the left and right two tooth surface grinding internal gear, a grinding out after a modification about two tooth surface to ensure the consistency of the size. In the grinding process, if the roll mill is found to wear out, it is necessary to use the vajra wheel in a timely manner to repair the rod mill.