The reasons for the high current of high pressure Raymond mill

In the high pressure Raymond mill, the fan is located at the lower end of the main engine. The main function is to blow the external air into the main engine room and drive the material up through the air flow. The fan plays a great role, and it is necessary to check the fan properly and adopt the appropriate method to deal with the increase of fan current.

High pressure Raymond mill

In actual production, the operating volume of the high-pressure Raymond mill is much higher, and the advantage of high frequency fan operation will lead to the increase of current. The following methods can be used to make the fan perform high performance.

1. Congestion of high pressure Raymond mill. Generally, the blockage of air duct can easily produce internal air which cannot be circulated, so that the fan working under the long working hours has a large workload and needs to bear more intensive work. In general, the air flow driven by the fan blowing in the word link increases the powder material, and the analytical machine is used to analyze and collect the fine powder. This process relies mainly on wind power of the fan. The smooth blockage is very easy to happen when the machine is turned off, the porcelain stone blower is informed to run, the powder in the air is settled, if it is not cleaned in time, it is easy to cause the powder to clog the pipe. This leads to the blockage of the high pressure Raymond mill, which causes the fan to be overworked, causing the heat to rise as the temperature rises.

Solution: the equipment is checked to see whether the powder is settled and the powder will be removed after the operation is stopped in the high-pressure Raymond mill.

2. The high pressure Raymond mill is too fast to cause the host jam, causing the fan to drop the current. For one reason, it is necessary to consider whether the material supply is too fast, thus causing the problem of internal material clogging. A good circulation effect cannot be formed between the whole sealing system and the host. This can cause damage to the main engine parts of the device, or cause the wind to fail, and the fan's current rise affects production.

Solution: to check inventory, check whether the wind road system with the host air circulation, check the equipment running status, clear in time blocking material, and decrease the feeding amount.

3. High pressure Raymond wear fan belt slack. The belt of the fan is too loose, which can cause the fault of the driving system, and the wind power is not enough to effectively blow the material, and the fan's overwork causes the current heating up.

Solution: in order to avoid affecting the output of the main engine, it is necessary to check the running state of each part of the fan regularly, and make the necessary fastening guarantee for the loose parts.

The problem that the fan current raised in the high pressure Raymond mill needs to be solved reasonably according to different causes, and to improve the situation to prevent the recurrence of similar situation. As long as the correct processing mode is handled, the current of the fan can be guaranteed to run normally.