Raymond mill has a knack for fighting the smog.

How does Raymond mill do the dusting protection? Ramon machine belongs to industrial powder equipment, dust emission is inevitable, how to reduce dust emission is the direction of the attention and development of Raymond mill. The specific measures are as follows.

Reason analysis and treatment of Raymond mill dust emission:

1. The material itself is dry, which will produce a lot of analysis during the crushing process, especially the feeding port of each device; Solution: in the equipment into the couple into the atomized dust protection, pay attention to sprinkle water should be strictly controlled, because Raymond mill humidity has obvious requirement for the material, otherwise the pipeline, feeder, filter filter bag can cause congestion phenomenon, humidity shall not be higher than 6%.

2. The milling production line is semi-closed structure, with the most dust in open connection; Solution: it can change the link between the equipment, and seal the inlet and outlet to prevent the dust leakage, such as the mouth of the jaw breaker, and the semi-closed component equipment such as silo.

3. The residual wind emission is a large amount of dust; Solution: install the filter, filter is very important to the production of flour, is now milling process of the necessary equipment, dust removal device quality directly relates the quality of the whole equipment, consider milling equipment based on sex now? Production capacity, processing capacity, equipment material, manufacturing process, environmental performance, etc.

4. Improper operation causes dust leakage; Solution: operate the machine according to the normal equipment, especially the fan, feed speed control, the material incoming material too fast, the air volume too much dust overflow problem.

5. Problems of equipment failure and increase of dust and dust; Solution: there are two reasons that cause this increased dust, one is the right state machine valve, not form a negative pressure in the production line, Raymond mill inlet have powder phenomenon, the second is, transportation equipment itself there are cracks or other reasons cause closed lax, dust leakage, both need according to the different way to find out the reason, the reasonable adjustment milling equipment.