What are the most overlooked failures of Raymond mill?

The large Raymond mill has a large production and finer grinding, but the large Raymond mill is time-consuming to inspect and manage. There are some minor faults that can easily be ignored, but some minor faults can easily lead to unnecessary failure and affect production. What are some of the most overlooked failures of Raymond mill?

 

1. The screw loosening and gasket wear of the pipe link is serious, which will cause the leakage of air leakage, which will affect the production, and must tighten the screws and replace the new washer;

 

2, air duct accumulation is too much material, this question will be ignored, so many people think that the material of the grinding chamber can be driven away, actually otherwise, some of the material being ground after a long time, will be smooth, not easy to be ground powder, slowly will be stored up in the air duct, a growing number of material accumulation, fan air volume can't move again, after a long time, the operation of the shovel will get great resistance, the material was thrown up shovel knife, will affect the production, in this case, will stop, the air duct the following open the door, to clean up;

 

3, fan triangle is loose, normal triangle firmness after should tighten, floating up and down 1 cm for the best, if is too loose, wind the opportunity to air volume is reduced, cause FenZi too thick and reduce yield, found that this kind of situation, should immediately adjust the firmness of triangle.