Raymond mill seriously vibration, the noise of the solution.

Raymond mill in use process, before feeding, the voice is bigger, roller in the grinding chamber rotation, uttered a loud metal rolling, which belong to the category of normal, when the material into the grinding chamber, the sound will become smaller, this is the roller in rolling material, because there are the material under the roller, so not so loud; In rolling process, the shovel DaoHui cast material, again by squeezing grinding roller, thus reach into a powder, finished product FenZi will be fan blowing up, through the analysis of machine analysis, again into the pipeline, finally fall into powder.

 

Raymond mill host vibrations of a lot of time, you should stop check, check whether the material accumulation, not to go out, resulting in vibration, and then check the Raymond mill grinding roller and grinding ring, is deformed or round, in this way, also easy to cause big vibration and noise, if it is, is replacing or roller grinding ring, can be troubleshooting; Still another reason can cause the shock, is the anchor bolt, anchor bolt looseness, Raymond mill host cannot be well fixed, when the material to enter, the rotation of the motor, will make the host, and cause the shaking big fault, this happens, should immediately stop, tighten the anchor bolts.

 

Interoperability of Raymond mill is very important, should be strictly carried out in accordance with the operating manual, failure occurs, immediately repair, shall not be forced to start with a failure of Raymond mill work, lest cause a greater loss.