Raymond mill the biggest problems at work!

Raymond mill as the most commonly used milling equipment in mines, in the flour milling industry can see the figure of the equipment, but as a mechanical device, after long-term use can appear some problems, more or less in specific appear what problem? The following professional ramon mill manufacturers to the frequent occurrence of several problems are summarized, hoping to help users to a certain extent.

1. There is no powder or less powder at work. This problem is usually a problem with the powder lock or shovel, which only needs to adjust the seal of the powder lock, and there is a better new shovel to solve.

2. The finished product is too thick or too thin. Because the analyzer is used to screen materials, if the finished products are not uniform in fineness, it should be that the analyzer has a problem. If the blade is badly worn, the blade of the analyzer needs to be replaced. If the speed is not up to the standard, the speed of the analyzer needs to be adjusted.

3. Fan vibration. Most of these phenomena are caused by powder accumulation or uneven wear on the blade or bearing wear or damage. If it is too much powder on the timely clearance, wear serious timely replacement.