Introduction to technical requirements for Raymond mill reassembly of bauxite

Raymond mill covers a number of patent technologies. It is a new type of equipment upgraded on the basis of the traditional grinding machine. The production capacity is raised by more than 40%, and the cost of unit power consumption is more than 30%. It is the best choice for bauxite processing. For bauxite Raymond mill price customization, we need to provide detailed processing information, we will do our best to provide your project with accurate product service.

 

Introduction to technical requirements for Raymond mill reassembly of bauxite

 

1. Bearing. The main bearing of the mill should be in contact with the bearing floor evenly. The main bearing has two kinds of spherical tile and waist drum surface. If the former is used, the main bearing sphere must be researched, the spherical surface should be in good contact and the action is flexible; if the latter is used, it needs no research.

 

2, bearing material, in the tile body need to leave cooling water channel, and carry out water inspection, can not have leakage phenomenon. The main bearing body of the casting copper alloy material does not need to leave cooling water channel.

 

3, bearing, Raymond mill bearing and hollow shaft clearance should be uniform, the maximum deviation is not greater than 1000mm.

 

4. The radial runout of the big gear after assembly is not greater than 0.125mm on the diameter of the pitch circle of each meter, and the end jitter is less than 0.15mm on the diameter of each circle.