What are the common failures of Raymond mill in operation?

We have been very familiar with Raymond mill, and the frequency of the use is very wide. As the scale of production is expanding, more materials need to be pulverized, and people are very full of the performance of Raymond mill in the actual operation, but the excellent equipment is not handled properly. There will also be problems. Today we will take a look at the common failures of Raymond mill in the operation.
For mechanical equipment, failure is a very common thing, but also a headache, but the problem is normal, the current situation is not a bit of fault do not happen, so the maximum effort to reduce the frequency of failure. As a new type of grinding equipment, the performance and structure of Raymond mill have been greatly adjusted in comparison with the traditional mill, so the frequency of failure is reduced much, but it is not a fundamental solution to the problem of failure. Normally.
Raymond mill has few failures, but sometimes improper operation or long-term use without maintenance will also be a problem, so the daily use of Raymond mill should pay more attention to these two points. The main task of Raymond mill is grinding powder, so the failure frequency of the grinding device is relatively high. When the material is too large, the material is too large, the humidity is too large, the hardness is too large, the material is not uniform and so on, the wear of the grinding parts will be caused, the light will slow down the working efficiency, the heavy weight makes the equipment strike and produces safety. Hidden dangers.
Now the Raymond mill is more automated. To reduce the frequency of the failure, it is necessary to require a higher quality of the ability and quality of the operator, so the operator of Raymond mill needs strict skill training. This can effectively reduce the occurrence of failure. In addition, Raymond mill has to be overhauled for a period of time. It is not only responsible for safety production, but also can effectively reduce the failure, increase the efficiency of production, and prolong the use time of the equipment. In addition to a large area of maintenance, we have to pay attention to some details, such as the replacement of grinding parts, and lubrication. The addition of oil and so on.