If you are interested in our products, Please get in contact with us .
E-mail: shuguang_mill@163.com Chat Line Send InquiryNo powder (normally no powder or less powder).
The reasons for this situation include: Raymond mill pulverized valve failure; Raymond Mill gas lock leaking or constant opening; pipe serious leakage; pipe valves entering the blower are too small; overfeeding; Raymond Mill pipeline system installation too long too high, too much elbow or too small angle at the elbow; the roller device card can not turn dead; The cutter head is worn more or the material is too wet.
Processing method: check whether the Raymond Mill powder valve and the lock gas are stuck or often open, blocking the leakage of the pipeline and whether the valve of the check valve is open. Check whether the roller device is stuck and blade wear. Change the height of the pipe and increase the angle at the elbow. Uniform feed. The humidity of the control material is less than 6%.
TEL: 0086-371-67666660
FAX: 0086-371—68125111
EMAIL: shuguang_mill@163.com
