What should I pay attention to when removing the bearings of raymond mill?

Raymond Mill is a special grinding machine, which can be viewed in all major mines. raymond mill has gradually become an important equipment in the milling industry, and bearings are important accessories for raymond mill. For Raymond mills, the installation, use, and disassembly of the equipment have to be carried out in strict steps. Take the raymond mill bearings, you need to pay attention to these when you need to replace them.

First of all, when disassembling the bearing, pay attention to the selection of the disassembly tool and the correct disassembly steps and sequence. Strictly observe these to effectively prevent the damage of the accessories around the bearing. When disassembling, first turn the bearing device out and then check the roller bearing. End gap, remove the roller sleeve and shaft assembly from the grinding roller head, after removing the fitting at a time, pull the inner ring of the bearing out of the grinding roller shaft, and then adjust the grinding roller bearing housing from the grinding roller shaft At this time, the outer ring of the upper and lower bearings is still left in the bearing housing, and the outer ring of the bearing is pulled out by using a suitable tool, so that the disassembly step of the bearing is completed.