Daily maintenance of kaolinite Raymond mill

After the failure of the kaolinite Raymond mill, the maintenance cost is very high. How to do the maintenance work in the daily work and reduce the probability of failure?

1. During the use of the mill, there should be fixed personnel responsible for the care, the operator must have a certain level of technology. Before the installation of the mill, the operator must carry out the necessary technical training to understand the principle performance of the mill and familiar with the operating procedures.

 
2. After using the mill for a period of time, it should be repaired and repaired. At the same time, the wearing parts such as the grinding roller and the blade should be repaired and replaced. The grinding roller device should be carefully checked before and after use to see if there is looseness. Whether the lubricating grease is sufficient.

3. In order to make the mill normal, the equipment “safe operation system for equipment maintenance” should be established to ensure the long-term safe operation of the mill, and necessary maintenance tools as well as grease and corresponding accessories.

 
4. When the grinding roller device is used for more than 500 hours to replace the grinding roller, the rolling bearings in the roller sleeve must be cleaned, and the damaged parts should be replaced in time. The fueling tool can be manually pumped and greased.

5. The scrapping limit of the grinding roller ring, the remaining minimum wall thickness shall not be less than 10mm.

6. When parking, stop feeding, the main machine continues to smash, and the residual abrasive continues to be milled. After about one minute, the main motor and analyzer motor can be turned off, the grinding operation is stopped, and then the fan motor is stopped. In order to blow off the residual powder.

The above is the method of daily maintenance. Customers who have invested in kaolinite Raymond mill are welcome to contact us.

E-mail : shuguangzhongji@163.com

Cel : 0086-13523465141