A move to easily maximize the productivity of kaolinite Raymond mill

Kaolinite Raymond mill is popular because of its low price and large output. But after using it for a while, these advantages are gone. The kaolinite Raymond mill has a lower and lower powder yield, which seriously affects the company's productivity. How to solve these problems has caused many companies to have a headache. What should be done?

 

There are many such methods in the industry. Shuguang Heavy Industry recommends that you choose the method that suits you according to your actual situation. The following is the corresponding solution for the different problems summarized by Shuguang Heavy Industry, which is convenient for you to increase the production of kaolin Leimeng mill.

 

Through daily maintenance and observation of the fineness of kaolin, it was found that the fineness was getting bigger and bigger, and the output was not as high as the original. After careful observation, it turns out that the active shaft speed is unstable and there is a tendency to slowly slow down. Do I need to change the drive shaft? The cost is quite high, and it is not very acceptable. Don't worry, look carefully and observe, oh, found out, the drive belt is loose, oh, some are almost worn out. Ok, the problem is solved. I will adjust the loose belt and replace the fast-freshing belt with a new one. It’s good, and it’s easy to raise the output.

 

Don't rush to the conclusion, Dawning Heavy Industry recommends that you also choose the main engine speed at the same time to improve the centrifugal force of the grinding roller. Do not forget to consider the bearing capacity of the main motor.

E-mail : shuguangzhongji@163.com

Cel : 0086-13523465141