Dolomite Raymond Mill can be used for 400 Dolomite grinding?

Today Dolomite Raymond Mill introduces the Dolomite Raymond Mill can be used for 400 mesh Dolomite grinding?

1). What are the advantages of Dolomite milling in Dolomite Mill?

1. High fineness of the finished product: Dolomite powder is evenly distributed after treatment by Dolomite Raymond Mill, and the sieve rate can reach 99%;

2. Strong wear resistance: the important parts of this machine are made of high quality casting and profile, with fine workmanship, which ensures the durability of the whole equipment.

3, low investment cost, compared with other milling equipment, the Dolomite Raymond Mill powder machine set crushing, drying, grinding, sorting conveyor at an organic whole, the system is simple, compact layout, covers an area of about 50% of the ball Mill system, but also open to decorate, so can reduce investment costs a lot;

4. High degree of automation: in the design, the Dolomite Raymond Mill's mechanical and electrical system adopts centralized control, and the selection of advanced and reasonable automation degree is high, and the grinding workshop can basically achieve no operation.

2). Which points should be paid attention to by Dolomite Raymond Mill?

1, before starting, to do a comprehensive inspection, such as: check whether all the access door closed tight, check whether the granularity of the object under ground is consistent with the feed particle size, adjust should be achieved approximate finished product granularity analysis machine speed requirements;

2. In the work, it is necessary to have a fixed personnel in charge of the supervision, and the operator must have certain technical level, and can make a certain reaction in time once the mechanical failure occurs;

3. Before stopping, the machine must be turned off to stop feeding, and then stop the machine, and then stop the blower after blowing off the powder. Finally, the analyzer can be turned off.